done with LANCER.
#17
Evolving Member
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Tracy Ca
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
Yep, be prepared to drive alot more cautious if you plan on going as low as me. You will scrape their is no avoiding it. Especially if it's daily driven. I've cracked my oil pan, scraped up my flex pipe, and my subframe bolts hit all the speedbumps i can't avoid and have to go over regardless if I'm going at it sideways or not, because they are the lowest point. They don't get harmed really at all though.
Last edited by Onkar02; Oct 11, 2010 at 01:27 PM.
#18
Evolving Member
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Tracy Ca
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
And i don't even consider my car low yet compared to the other stanced cars out there. It is really low for a base lancer though.
Last edited by Onkar02; Oct 11, 2010 at 01:28 PM.
#20
Evolving Member
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Tracy Ca
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
haha yea skid plates? yea ive thought of it. not like seriously though. its not that bad. the oil pan is high enough to avoid mostly everything. idk how i cracked it. guess just bad luck. it should be fine if you just drive normal. i tend to drive faster than i should with my car being stanced and all. then again i dont really care about my lancer like i do with my Z. i treat my lancer pretty bad. i just dont care lol haha. I baby my Z though.
#21
My old cars. I've only driven slammed cars. Roads around here are so-so. With the suspension on the Lancer, I wont be nearly as low as you or my older cars. Just a good drop for a quality ride and better handling.
#22
Evolving Member
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Tracy Ca
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
Yea.. I herd bc coils do a pretty nice job and they are priced well. Lots of stanced cars roll on bc without problems. Im on ksports. They suck. But I got em on here for cheap lol
#23
I had KSports on the Neon. I had them pre-loaded and everything right but they still blew and seized. Oh well, gotta pay to play. I've heard nothing but good reviews for BC coils.
Do you only have the OZ front lip, or the whole kit? I'm searching all over the internet for that lip kit.
Do you only have the OZ front lip, or the whole kit? I'm searching all over the internet for that lip kit.
#24
Evolving Member
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Tracy Ca
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
I had KSports on the Neon. I had them pre-loaded and everything right but they still blew and seized. Oh well, gotta pay to play. I've heard nothing but good reviews for BC coils.
Do you only have the OZ front lip, or the whole kit? I'm searching all over the internet for that lip kit.
Do you only have the OZ front lip, or the whole kit? I'm searching all over the internet for that lip kit.
#27
Evolving Member
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: Tracy Ca
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
yea i wish i had just saved and got bc coils.. oh well lol. and tell me how the camber kit install goes. i didnt get them. really no need as long as you rotate your tires every oil change. its not the camber that does the excessive wear. its the TOE.
#30
Evolving Member
Join Date: Nov 2003
Location: HAWAII
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts
good job man.. my lancer was bout to be sitting flushed and stretch with work varianza's D3S. but i sold it to this kid $4500 without the WORKS and gave him the ROTA GT3 instead.. then i sold my WORKS to get me the same WORKS on My TSX working on it to be flushed..
your right bout the sub frame bolts, flex pipe and oil pan scraping for sitting VERY LOW but my oil pan bolt was the only thing that got jacked up from the oil pan. i cant believe u crack your pan i guess i was lucky for it to not crack.
like i said your one of my top fave rides on here good job man!
your right bout the sub frame bolts, flex pipe and oil pan scraping for sitting VERY LOW but my oil pan bolt was the only thing that got jacked up from the oil pan. i cant believe u crack your pan i guess i was lucky for it to not crack.
like i said your one of my top fave rides on here good job man!