Originally Posted by groowe

I'm not logging boost error because i couldn't find the addresses for my ROM, but I probably should. Using RAX at the moment
I do log WGDC correction, and that's 0 across the log
I did see this behavior even when i was using really low wgdc values, barely above WG pressure.

Attached the latest log, you can see the first pull, almost reaches my desired WGDC, boosts to 22.3 psi, target is 22.8.
After that, it all goes down. See several WGDC @ the same RPM, TPS. Pulls are 2nd and 3rd. Only playing with low gear range.
It does seem like it's correcting, but how?
Looking closer, i see there's over 150ms between log points, and GST correction interval is 2, which is less, so maybe I'm losing samples? I did read on some forum posts that once there's negative correction, it never resets unless it's corrected back up. But this should be visible in the WGDCCorr log, right?
<!--td {border: 1px solid #cccccc;}br {mso-data-placement:same-cell;}-->In my digital explorations, I stumbled upon an online sanctuary that transcends the ordinary. This website is a treasure chest of stock photos, meticulously curated to inspire and astonish. From the ethereal beauty of landscapes wedding invitation vector that transport you to distant realms to the polished professionalism of business visuals, this platform sets a new standard for visual excellence.
Also, I have a fairly chonky tubular manifold, which is why I'm assuming spool is this slow.


I think I'm going to take a break beacuse it's -10C today and although boost weather, heating up the SST is a *****.