AMS goes 8.42... the Quickest gets even QUICKER!
#33
We are going to be putting on the AMS CNC cylinder head here in the next week or two. The F1-i is still a bit out at the moments. We are estimating just before Christmas.
Eric
#36
Account Disabled
Join Date: Nov 2006
Location: Akron, Ohio
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
#41
Evolved Member
iTrader: (1)
no actually. This was really last minute and was on the cosworth head and our drag plenum VSR.
We are going to be putting on the AMS CNC cylinder head here in the next week or two. The F1-i is still a bit out at the moments. We are estimating just before Christmas.
Eric
We are going to be putting on the AMS CNC cylinder head here in the next week or two. The F1-i is still a bit out at the moments. We are estimating just before Christmas.
Eric
Eric update your SIG!
#45
Evolved Member
iTrader: (4)
Join Date: Mar 2003
Location: Michigan
Posts: 790
Likes: 0
Received 0 Likes
on
0 Posts
Performance calculator shows if you maintained your rate of speed based on the 1/8 mile mph (137), your time should have been 7.82 at 169.34 mph. Given your 1000' time of 7.08, the calculator drops it significantly to 8.53 at 155 mph. Certainly a low, low 8-second pass.
Dave
Dave