Injector scaling for PTE 1200's
#16
Evolved Member
Thread Starter
iTrader: (26)
Join Date: Oct 2007
Location: Colorado Springs, CO
Posts: 1,989
Likes: 0
Received 0 Likes
on
0 Posts
Okay...
Leaving the Global Scaling at 750, I've been reducing my latencies in hopes of taming the positive mid trim.
Here's some general information that I've gathered today.
Mid: +10.9
Low: -1.4
5.568
3.144
1.920
1.248
.938
.528
.312
Mid: +10
Low: .49
5.472
3.096
1.872
1.200
.912
.528
.312
Mid: + 9.7097
Low: + .49
5.280
3.000
1.776
1.152
.864
.528
.312
Am I on the right track decreasing the dead time bit by bit??
-E
Leaving the Global Scaling at 750, I've been reducing my latencies in hopes of taming the positive mid trim.
Here's some general information that I've gathered today.
Mid: +10.9
Low: -1.4
5.568
3.144
1.920
1.248
.938
.528
.312
Mid: +10
Low: .49
5.472
3.096
1.872
1.200
.912
.528
.312
Mid: + 9.7097
Low: + .49
5.280
3.000
1.776
1.152
.864
.528
.312
Am I on the right track decreasing the dead time bit by bit??
-E
#17
make the global smaller and it will make bigger changes in mid trim
ps i did not read your previous post before sending you pm .
you can see from the logs you posted that your low trim went from minus to plus by changing your dead time but the low change was greater than mid. when you lower your global down from 750 the mid will change more than the low. It is a balancing act of sorts.
ps i did not read your previous post before sending you pm .
you can see from the logs you posted that your low trim went from minus to plus by changing your dead time but the low change was greater than mid. when you lower your global down from 750 the mid will change more than the low. It is a balancing act of sorts.
#29
Evolved Member
iTrader: (30)
Join Date: Oct 2006
Location: Fl/Jam
Posts: 780
Likes: 0
Received 0 Likes
on
0 Posts
Could it be this?
https://www.evolutionm.net/forums/8794310-post98.html
https://www.evolutionm.net/forums/8794310-post98.html
Thread
Thread Starter
Forum
Replies
Last Post
TheBigD
General Engine Management / Tuning Forum
8
Mar 3, 2013 10:14 AM