anyone have pte 1000'cc values?

Help me get to the tuner.. 2 1/2 drive.

 

E85 or pump gas?

I have latency values for you

-E

 

sorry,, pump gas.

 

PM being sent...

-E

 

so iv read through the first 20 pages and will continue on tomorow however i figured id post my question to see if anybody can help..

I will be installing rc1000's soon. i just need what number and latency's i should scale them with to start. i found the post with the list of a bunch of injectors and latency's however it doesn't say anything about the scaling..?.. lil help please

 

bump. i know somebody knows. please share the knowledge

 

 

PM me if anybody wants the values for the ID Bosch 1000cc/min

 

ok so i bought a set of precision 680 injectors, followed the instructions here and from friends who have also installed them, im getting a wierd issue though...and its the reason im posting, first is that i had to go to 696 scaling to get them close to zero trims and that once at zero trims if i try to go into boost it goes wayyyyy lean, has this happened to anyone else? i bought the injectors used from a local shop, they said they were precision 680's

any help would be very very appreciated as im stressing out since i dont know what to do

 

what is your 14volt latency?

 

i used the latencys in the AEM wizard for PTE 680s

 

Try these for PTE 680's

3.312
2.184
1.416
0.960
0.696
0.480
0.360

Scale to 650cc

 

i've landed @ this exact scaling and latency for my pte680's

 

I asked what you 14v latency was to see if they lined up with Cossie1 s values.
His numbers are the go!

 

Does anyone have some really good settings for PTE 780cc injectors as I recently changed from 680's (where the above settings worked spot on for me) and I am not having much luck with the 780's so far.