Throttle hang and the Idle Stepper Table
#498
Evolving Member
thx for the info.
The only problem I have now is that every now and again when I turn a corner at low speed, like you do in a parking lot, the car will sometimes die.
And very now and again, when coming to a stop at the traffic lights.
Any idea what might be causing the problem?
Thx
Last edited by SeanV; Feb 12, 2010 at 07:43 AM.
#499
Evolved Member
iTrader: (22)
Join Date: Nov 2003
Location: Northern KY near Cincy
Posts: 2,408
Likes: 0
Received 6 Likes
on
6 Posts
you may need to slightly raise the last 2 values of the ISCV tables. Raise them a couple points....all of the tables.
In addition, if you have cams, you might want to raise you base idle settings a little.
In addition, if you have cams, you might want to raise you base idle settings a little.
#500
Evolved Member
iTrader: (33)
hey guys i have a question, i am using tephra's v7 88590715 and i do not see the decel fuel cut tables and i was looking at my idle stepper table and notices that the x and y axis do not match up to what i saw in Merlin's tuning guide. one side is unknown units and the other is coolant temps but it seems that the values are off scaled.
i also have throttle hang and its annoying at times especially when trying to stop and it feels like the brakes are slippery.
is there something i can do about the scaling in the stepper table?
BTW i have the S2 mivec cams and idle is set to 1031
i also have throttle hang and its annoying at times especially when trying to stop and it feels like the brakes are slippery.
is there something i can do about the scaling in the stepper table?
BTW i have the S2 mivec cams and idle is set to 1031