EvoScan v0.98 Now with Power & Torque Graphing - Map Tracing completed also!
#469
Newbie
iTrader: (1)
Join Date: May 2006
Location: Dominica
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
thanks
let me try to get these right...
AccelEnrich- used only as a momentary adder for fueling as you are moving the gas pedal, to prevent a lean tip in moment, like an acclerator pump on a carb
FuelTrim_Low/mid/high-only used in closed loop operation(around town driving) and the computer ignores these while at WOT
CoolantTemp-once warm, a properly function cooling system is supposed to keep this a very stable number. If the temperatures climbs more than a few degrees on a dyno/street pull, youve got issues that need addressing
O2FeedbackTrim-again, during closed loop only, this is what the comp uses to reference fuel trims off of
O2Sensor- should be the precat sensor, if fueling is correct this wont change a lot either, indicating steady fuel trims, just not giving accurate reading for tuning off of
O2Sensor2-I think this is the post cat o2, which is used just for emmisions purpose
I think I got all of this right, but someone let me know if I screwed up.
AccelEnrich- used only as a momentary adder for fueling as you are moving the gas pedal, to prevent a lean tip in moment, like an acclerator pump on a carb
FuelTrim_Low/mid/high-only used in closed loop operation(around town driving) and the computer ignores these while at WOT
CoolantTemp-once warm, a properly function cooling system is supposed to keep this a very stable number. If the temperatures climbs more than a few degrees on a dyno/street pull, youve got issues that need addressing
O2FeedbackTrim-again, during closed loop only, this is what the comp uses to reference fuel trims off of
O2Sensor- should be the precat sensor, if fueling is correct this wont change a lot either, indicating steady fuel trims, just not giving accurate reading for tuning off of
O2Sensor2-I think this is the post cat o2, which is used just for emmisions purpose
I think I got all of this right, but someone let me know if I screwed up.
#471
Evolving Member
iTrader: (3)
Join Date: Mar 2005
Location: Grand Rapids, MI
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
I ran into this problem as well. Try making sure your cable drivers are installed and working correctly. I ended up removing the device and letting it reinstall, after that I was able to log successfully with .99.
#473
Evolved Member
iTrader: (4)
wait a sec here, so did v.98 ever get officially released? I gotta admit, I got tired of reading all of the BS in this thread around page 15. I swear, if you took out all the crap, kinda like my post apparently, you would only have 2 or 3 pages of stuff to read. So, back to my original question, did .98 ever get properly released with the bug fixes? Or are we jumping to .99 on the down low?
Thread
Thread Starter
Forum
Replies
Last Post
mscorei
General Engine Management / Tuning Forum
9
Aug 1, 2007 04:10 PM
evo4mad
ECU Flash
141
Oct 12, 2006 11:30 PM