Tuning 1000cc injectors on ECU Flash
#16
Evolved Member
iTrader: (4)
I think the only limitation of the stock ECU is your patience. Already the stock ECU has been shown to run a GT35r, which was previously thought to be impossible. I see you got your mid ft's down in the 90's. Let me know how your cruise stuff goes. That was the toughest part for me with the larger injectors.
#17
Evolved Member
Thread Starter
iTrader: (52)
Join Date: Sep 2005
Location: Boston,MA
Posts: 1,522
Likes: 0
Received 0 Likes
on
0 Posts
I think the only limitation of the stock ECU is your patience. Already the stock ECU has been shown to run a GT35r, which was previously thought to be impossible. I see you got your mid ft's down in the 90's. Let me know how your cruise stuff goes. That was the toughest part for me with the larger injectors.
#18
Evolved Member
iTrader: (17)
Join Date: Nov 2005
Location: NNJ
Posts: 2,544
Likes: 0
Received 0 Likes
on
0 Posts
#20
Evolved Member
iTrader: (2)
Join Date: Oct 2002
Location: Somewhere
Posts: 1,328
Likes: 0
Received 0 Likes
on
0 Posts
If you go by Hexadecimal .. the theoretical limit of the injector sizing is 29000+
Anyway .. it's a reducing value .. ie the higher the injector you set .. the lower the value in the ROM .. so the lowest valid number you can go to is 0x0001
For 1000cc injectors to idle within +/- 5% of fuel trims, I have mine set to 913 (0x0020) and latency of 0.960ms@14.06v
Anyway .. it's a reducing value .. ie the higher the injector you set .. the lower the value in the ROM .. so the lowest valid number you can go to is 0x0001
For 1000cc injectors to idle within +/- 5% of fuel trims, I have mine set to 913 (0x0020) and latency of 0.960ms@14.06v
#29
Evolving Member
iTrader: (8)
Join Date: Jul 2006
Location: Silicon Valley
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
I think part of the confusion stems from the injector latency value only topping out at 7XX (or 8XX I forgot). People don't realize you can manually input higher figures thus claim it's limited. Personally I have tuned with 1000cc's w/ with ecu flash and had no issues.
#30
Evolved Member
iTrader: (30)
Actually its not the latency value that tops out, you meant the scaling value I think. It just dawned on me in when I was disabling my rear O2 subroutine a few weeks ago (and again this morning on an different map) that it might be possible and sure enough it worked (well as far as inputing the number anyway). I havent had a chance to try it out on anyone yet though as I only have 750's.
p.s. its 770cc
p.s. its 770cc
Last edited by JohnBradley; May 2, 2007 at 09:23 PM.