tkklemann

iTrader: (6)

I have mine set at 80 because I am trying to monitor that damn part throttle knock with the OEM Mitsu timing numbers..

evo828

For that annoying part-throttle knock I have raised the threshold to 150 - so it doesnot scare me

Youngsyr

iTrader: (1)

AKA "The Ostrich Solution"?

Chamama

So, How does the stock car behave? Partial throttle knock? WOT knock?

I set mine to 120 load, 4 counts. I have seen once it starts knocking at a low level and I continue WOT, the knock sometimes builds or continues. But If I let off the throttle, and then again go WOT knock disappears.

justboosted02

iTrader: (31)

bump for more input

mine is at 80 load and 2 knock counts but thats just cause im doing initial part throttle mapping on the new setup

TouringBubble

iTrader: (2)

Mine is at 0 load and 2 counts currently as I was looking for knock in traffic. I usually set it at 120 load and 3 counts.

evoredy

iTrader: (7)

150% load, 3 counts slow blink.

MR Turco

iTrader: (16)

100 load 3 counts slow blink 6 counts high. i would get too much blinking at 80 from part throttle.

cossie1

165% load 3 counts slow 4 counts high