evoscan incorrect dtc list air intake, engine coollant, presure sensor, knock sensor
#1
Newbie
Thread Starter
Join Date: Jan 2008
Location: uk
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
evoscan incorrect dtc list air intake, engine coollant, presure sensor, knock sensor
hi people im new to this kind of fault diognosis but i find it hard to belive that i have the following errors on my car as they come and go each time i look at the dtc list
air intake
engine coolant
vehicle speed sensor
barometric sensor
knock sensor
fuel pump relay
but if i interrogate the sensors they look to be displaying the correct values as best as i can make out any way for example the engine coolant starts low and as the car heats up rises steadly
any help much appreciated
mark
air intake
engine coolant
vehicle speed sensor
barometric sensor
knock sensor
fuel pump relay
but if i interrogate the sensors they look to be displaying the correct values as best as i can make out any way for example the engine coolant starts low and as the car heats up rises steadly
any help much appreciated
mark
#5
Evolving Member
mark - I used to have the same when I tried the check fault codes in Evoscan when the engine was running. Switch the engine off but let the ignition on - see what comes then.
No fault codes have been shown on scantech - so I assumed it is just going crazy when you run check faults when engine is running.
No fault codes have been shown on scantech - so I assumed it is just going crazy when you run check faults when engine is running.
#6
Evolved Member
iTrader: (37)
Join Date: Sep 2003
Location: Spec-Ops Motorsports, Fayetteville, NC
Posts: 3,146
Likes: 0
Received 2 Likes
on
2 Posts
i have tried this function a million times with the car running and it always returns some crazy faults.... i have yet to try it with the car off but the key in the on position. I just chalk it up to a function that doesnt work and i use my scan tool
#7
Newbie
Thread Starter
Join Date: Jan 2008
Location: uk
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
i have downloaded scantech but i cant get it to work with the car (mitsubushi space waggon) or my lead that i brought from evoscan websits, OpenPort 1.3U Cable
i have emailed evoscan if i get a response i will let you all know
i have emailed evoscan if i get a response i will let you all know
Thread
Thread Starter
Forum
Replies
Last Post
AlwaysinBoost
Evo Engine / Turbo / Drivetrain
15
Nov 5, 2011 10:45 AM
BadazzCR
Evo Engine / Turbo / Drivetrain
3
Aug 23, 2008 07:40 AM