Evo Ix Ecu Pins Are Here!
#46
4) Use the correct gauge wire for the ECU pin. I tried a 14 ga and it didn't want to work. I ended up going with a short piece of 18 ga I had left over from another project and connecting to the 14 ga I'd already run. It also helps if I ever need to disconnect it since I used a blade connector for this.
#47
Evolved Member
iTrader: (2)
Nearly the entire crimp tab in the rear is visible above the plug, whereas the stock pins sit about 3/64 in to the plug itself. It's almost like the rear tab shouldn't be there at all.
But, the pin sits correctly and makes a good connection. The lock also fits correctly over the pin.
It clips in correctly as well, but I actually broke mine (not sure if it was the pin or the plug) removing the pin the first time. Since it wasn't fully inserted as I'd expected, I tried to remove it and the wire slipped out of the pin. So, I used pliers to remove it and broke the latch. With the lock in place it doesn't move though.
The 18 ga I used worked out great. It is a little larger than the other wires but it fit the pin snugly and there were no clearance issues.
But, the pin sits correctly and makes a good connection. The lock also fits correctly over the pin.
It clips in correctly as well, but I actually broke mine (not sure if it was the pin or the plug) removing the pin the first time. Since it wasn't fully inserted as I'd expected, I tried to remove it and the wire slipped out of the pin. So, I used pliers to remove it and broke the latch. With the lock in place it doesn't move though.
The 18 ga I used worked out great. It is a little larger than the other wires but it fit the pin snugly and there were no clearance issues.
#57
I forgot to make a post earlier this week but the last of the EVO IX pins were sent out to the people who pre-purchased an EVO VIII Alt-Map Harness from me. If you don't get any within the next few days, PM me. So far people have been safely getting them in the mail so I'd expect them VERY soon. Don't be alarmed if you get an envelope from Rhode Island with a small ziplock baggy taped inside. Bnice thought someone sent him some Anthrax or something,lol. I sent everyone a single pin with an inch of wire already installed, along with 2 uncrimped pins. Thanks guys!
#60
Evolving Member
iTrader: (8)
Join Date: Nov 2005
Location: Phoenix
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Hey guys, considering making my own harness. Just have on quick question and don't really have time to read 1000+ post. Are the resistors getting hot at all? If so what did you use to keep them from burning holes in other wires? Thanks in advance.