OmniPower 4 bar settings
#61
EvoM Guru
iTrader: (50)
After installing the omni 4 bar and implementing the proper changes found here and on mrfred's thread, I have found that I'm getting a bad lean condition after boosting then adjusting the throttle back slightly, but still boosting. I loose power, it stumbles for a second, then the afr goes back to normal, all while having the throttle in the previous adjusted position. Can anyone help?
#62
Evolved Member
iTrader: (1)
Ah! Didn't know you made a new thread. I'm using 96940011. In comparison to the jdmmap settings, I've noticed the only differences are in the "Map comparison" and "Map vs Maf". Did I miss anything else?
Also, I'd like to understand how this sensor works. For what reason does the map scaling voltage end at 3.63? Shouldn't it read upto 5 volts? Or is that because all units above 3.63 volts are supposed to be 255? Thanks.
I'll try these new settings tomorrow and hope for the best! Thanks a lot!
Also, I'd like to understand how this sensor works. For what reason does the map scaling voltage end at 3.63? Shouldn't it read upto 5 volts? Or is that because all units above 3.63 volts are supposed to be 255? Thanks.
I'll try these new settings tomorrow and hope for the best! Thanks a lot!
Last edited by D-VO; Aug 12, 2009 at 09:06 PM.
#66
After installing the omni 4 bar and implementing the proper changes found here and on mrfred's thread, I have found that I'm getting a bad lean condition after boosting then adjusting the throttle back slightly, but still boosting. I loose power, it stumbles for a second, then the afr goes back to normal, all while having the throttle in the previous adjusted position. Can anyone help?
aaron
#67
Evolved Member
iTrader: (9)
Ok, I'm tuning the SD setup, and I've gotten my omni 4 bar map sensor scaled in on the Tephra v7 mod patch as close as I possibly can get to matching up with the stock maf values I logged the day before. Everything looks good as far as fuel table-wise, but I'm getting some stumbling due to both my LTFT Low and Mid being at -12.45% right now. What is the best way to bring them back in check to where I had them previously with the stock maf (at around the 2.2% mark for LTFT Low only)?
Thread
Thread Starter
Forum
Replies
Last Post