Virtual Dyno Room-Dyno Simulator
#1323
Evolving Member
iTrader: (13)
shouldnt matter if you installed with a previous version as it will auto update to the latest version. I just graphed it as well and it looked fine to me.
Goto Start -> Control Panel -> Region and Language -> Make sure its set on English (United States) and see if that helps.
Goto Start -> Control Panel -> Region and Language -> Make sure its set on English (United States) and see if that helps.
#1324
Silver Sponsor
iTrader: (-1)
Hi guys!!! I have a problem with this program, I can't do a good dyno, I'm doing something wrong, the program shows excessive hp and torque. This is my log file maybe someone can check:
https://www.evolutionm.net/forums/at...tor-jonlog.zip
https://www.evolutionm.net/forums/at...tor-jonlog.zip
I tried it in virtual Dyno for you, and I tried your log in EvoScan v2.9 beta… not so great pile of knock sum 13 you have at the end there, even though it’s quite rich in fuel, do you have a boost sensor you can log also?
Oops I just noticed EvoScan beta v2.9 has the HP and Torque @rpm around the wrong sides. I better fix that.
Couple of things I noticed… In EvoScan I had to set drag co-efficient all the way to 0.5 to make the same hp as VD1.1.4 which only has a drag co-efficient of 0.38… I’m guessing my horsepower calculations work slightly differently than virtual dynos. I might have to reprogram my hp calculations a bit to match up? any ideas Brad?
hey jonmerera,
I had the same problem too when i was trying to import to VD1.1.4. I would just go back through evoscan, locate the time of the pull, and than copy and paste only the run data into the simulator when viewing the log in exell. It worked fine everytime since. too much data confuses VD1.1.4
I had the same problem too when i was trying to import to VD1.1.4. I would just go back through evoscan, locate the time of the pull, and than copy and paste only the run data into the simulator when viewing the log in exell. It worked fine everytime since. too much data confuses VD1.1.4
Brad you could program it so that those countries that use commas as decimal seperators will still work without changing their regional settings. I programmed into EvoScan a few years ago to replace all commas with decimal points. that way .net can process the calculations correctly.
I noticed in Virtual Dyno even with boost/afr smoothing turned off, I still couldn't see the real 13.2 AFR reading @ 4125rpm that I could see in EvoScan … might be still some form of spline chart series smoothing Brad? can you turn that off?
Thread
Thread Starter
Forum
Replies
Last Post
mrfred
ECU Flash
496
Sep 14, 2022 07:08 PM
PIE-R
Evo X Engine Management / Tuning Forums
6
Dec 21, 2019 08:14 PM
Kami Speed
EvoX 'For Sale' Electronics / Lighting / Audio
9
Feb 20, 2010 03:55 PM