changes in fuel map does not have effect . why ?
#1
Newbie
Thread Starter
Join Date: May 2009
Location: georgia
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
changes in fuel map does not have effect . why ?
hi all ! my car is stock evo 9 mr . cat deleted and running 1.3 bar boost. (modified restrictor near the turbo). when i make changes on WG map ignition map and others there is some changes aplyed. but when i tryed to tune fuel map and monitoring result with innovate wideband the result was always the same . after 5000rpm goes 10.7 and after 6500 goes 10.2 . any ideas ? thanks !
#2
Evolving Member
iTrader: (2)
Join Date: Oct 2006
Location: Soquel, CA
Posts: 355
Likes: 0
Received 0 Likes
on
0 Posts
there are 3 fuel maps on Evo9's, you need to tune the correct one for the changes to make a difference - which is the second one I think, but you should double check that so you dont mess things up.
#3
Newbie
Thread Starter
Join Date: May 2009
Location: georgia
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
when i open my rom in ecu flash i see 3 ignition high octane fuel maps and 3 ignition low octane fuel maps. but in fuel i see 1 high octane fuel map and 1 low octane fuel map. maybe something wrong with my definition file ? (i am using latest)
Trending Topics
#9
Newbie
Thread Starter
Join Date: May 2009
Location: georgia
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
ok. if number in map was 9.8 after modyfiing it was 11.8 and nothing changes. also putting 7.8 does nothing ,same result. and other question when i log LOAD which parametr need to log LOAD CALCULATED ?
#14
Newbie
Thread Starter
Join Date: May 2009
Location: georgia
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
#15
Newbie
Thread Starter
Join Date: May 2009
Location: georgia
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts