94170015 ROM with 2 Byte load
#17
Evolved Member
iTrader: (14)
still not working logging with my openport ... although I havent tried evoscan yet.
I have noticed the table values are odd. The high load/rpm/airflow are good, they show either the hex or the numeric value that they should.
But the low values are off on ALL
And again, if I try to change it to the correct value (address?), it changes the corresponding High value
I have noticed the table values are odd. The high load/rpm/airflow are good, they show either the hex or the numeric value that they should.
But the low values are off on ALL
And again, if I try to change it to the correct value (address?), it changes the corresponding High value
#18
Evolving Member
Join Date: Apr 2011
Location: West Seneca NY
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
oh, ok so I dont need to use that.
Well I have another problem. When I go into ecuflash and open my 2 byte load HIGH and LOW tables, what values are supposed to be input?
I have put in 0x895C for high and 0x895D for low, but whenever I change each, the other table automatically changes!!! both will not stay constant
Well I have another problem. When I go into ecuflash and open my 2 byte load HIGH and LOW tables, what values are supposed to be input?
I have put in 0x895C for high and 0x895D for low, but whenever I change each, the other table automatically changes!!! both will not stay constant
Did you watch any of the Ecuflash training videos made by recompile?
i do believe he says in the video that changing one table might also change the other since some are looked up from the same address. Id watch them again to be sure.
Athanasios
#20
Evolved Member
I am trying to log 2byte load, RPM, and I dont really need airflow, but Im doing it for ****s and gigs.
I am logging without a laptop using an Openport 2.0, So I am also developing the correct codes for that. But its pretty simple, you just point it in the direction and it logs it. For the 2byte load, for example, my code is:
paramname=Load2byte
paramid=0x00
scalingrpn=x,0.3125,*
with 0x00 being 895C (at least I hope)
I am logging without a laptop using an Openport 2.0, So I am also developing the correct codes for that. But its pretty simple, you just point it in the direction and it logs it. For the 2byte load, for example, my code is:
paramname=Load2byte
paramid=0x00
scalingrpn=x,0.3125,*
with 0x00 being 895C (at least I hope)
Don't you need:
paramname=Load2byte
paramid=0x00
databits = 16
scalingrpn=x,0.3125,*
...for 2-byte value?
If that's the problem, you owe me
Rich
#23
Evolved Member
Thread
Thread Starter
Forum
Replies
Last Post