TephraMod V7
#1832
http://evoecu.logic.net/wiki/File:94170715-v7.zip
that one.. let me know.. if not where is your post with the correct one?
that one.. let me know.. if not where is your post with the correct one?
#1833
http://evoecu.logic.net/wiki/File:94170715-v7.zip
that one.. let me know.. if not where is your post with the correct one?
that one.. let me know.. if not where is your post with the correct one?
<table name="94170715 GEAR Fix1" category="TephraMod-V7" address="3f16e" type="1D" scaling="Hex16"/>
Old 0x6a2c to 0x8a2c
#1834
#1839
hello
I'm in trouble with the 94170715 phenem rom psi ecu boost control :O what is your problems ?! will it work download from wiki ? The Option 4 96530706 (v7 + Mods) rom is better ? It also has mrfred psi based boost control. With the 96530706 I shoud write in the Omni power 4 bar calibration ?
In the 96530706 everything is working ?
I'm in trouble with the 94170715 phenem rom psi ecu boost control :O what is your problems ?! will it work download from wiki ? The Option 4 96530706 (v7 + Mods) rom is better ? It also has mrfred psi based boost control. With the 96530706 I shoud write in the Omni power 4 bar calibration ?
In the 96530706 everything is working ?
Last edited by VGergo; Jun 13, 2010 at 01:33 AM.
#1840
Concerning the EVO X Tephra ROM Dave says:
Can this revised algorithm be implemented in the Tephra V7 ROM's?
If your coming from Evo 7-9 you may notice that there is a slight difference in the algorithm. NOW the CEL lamp will only flash when the knock STARTS above the thresholds. I have done this to stop low load knock from causing the CEL to flash when you pass above the load threshold.
Can this revised algorithm be implemented in the Tephra V7 ROM's?
#1843