GM IAT sensors and spoolin up speed density adapter so that I didn't have to cut the maf plug. You can also swap it out with the fuel temp wires as well I believe.

 

hey guys, can you explain me when these tables are triggered either first or the second
and whad does that % mean on the right column
also what does "fuel cut multiplayer" table do


photo hosting

 

You use one set or the other, not both.

They are triggered when those loads are reached x for the time period milliseconds indicated in the boost limits table.

 

you mean in boost cut delay table ? (I have 1000 ms there)

so looking at the first table, if I hit 230 load @4000 rpm for more that one second, ecu will cut the fuel ? I understand correctly ?

 

if you use (fuel cut load x2) in rom turbo section ecuflash it uses the higher set of tables and yes for the boost cut delay

 

Is there a table for injector shut off time? If Im in gear at lets say 5k rpm and let off the throttle and coast to idle my injectors kick on and off starting at about 2500 rpm. I would like to control this if possible.

 

can you have different boostsettings with map switching?, I need 2 boostsettings.

 

Yes.

 

 

Just donated for a copy of 90550701-mods, all the tables are empty and I can't enter values into them.

Any help greatly appreciated.

G.

 

Hey Gavin,

Do you have a base 90550001.xml in your ecuflash directory?

 

The 90550001.xml is in there and I've tried a couple of different versions downloaded from around the place. I've also tried different versions of Ecuflash, just to be sure.
90550001-v5.10fix-mods also doesn't load properly, I get the rom definition but nothing else.

But then 96530706-MBforVII_base and others work perfectly, so I don't know what is going on. It's like it's not reading the xml's properly??

TephraMOD-90550701-v7 is only 12kb, which is kinda small compared to some of your other mod files?

I'll try installing it all on another computer and see if that helps, obviously others aren't having these problems so it must be a hardware/setup thing at this end.

G.

 

open the XMl and look at what file it is inheriting. then check to confirm you have those files in the ECUFlash folder.

also, if the table shows with no data, then it is usually a scaling issue. either incorrectly defined or not at all.

cheers

 

Is it possible to have anti lag on the alternate map by retarding about 25 degrees the ignition for example?

 

We've been discussing stock ecu anti lag for a while. and what you're asking doesn't work to the effect of producing boost. Further more I have started a whole thread which thus far has reported nearly no effect according to anyone except John Bradley and Evors. I'm working on it though.,