TephraMod V7
#601
tested: 3D maps, valet, alt. maps, knock cell, big maps, all good!
Edit: that was it! Thank you!
Last edited by nonschlont; Oct 21, 2009 at 08:38 PM.
#603
#607
Its not working, (most likely) cause youre not adding the .xml's properly...
You need to go through the comp./program files/ecuflash/rometadata etc. If you just open up the file folder on your desktop, it will NOT work.
#609
thanks for your time... I take it I would have to copy my existing stock map over to it also?
just noticed I have to use one that has the same internal id right?
mines 88590015 which i only see 14 thanks
just noticed I have to use one that has the same internal id right?
mines 88590015 which i only see 14 thanks
Last edited by BoostWhore; Oct 21, 2009 at 03:24 PM.
#610
Question for you guys. Which MAF tables are no longer used when Speed Density is implemented? I know the following won't be used:
MAF Size
MAF Scaling
MAF Compensation
MAF Sensor Filtering
I assume....
Relative Air Density vs Temp for Airflow/Hz
Airflow/Hz Baro and Air Temp Compensation
...wouldn't be used either but I'm not sure. Any other tables no longer used with SD?? Thanks guys!
MAF Size
MAF Scaling
MAF Compensation
MAF Sensor Filtering
I assume....
Relative Air Density vs Temp for Airflow/Hz
Airflow/Hz Baro and Air Temp Compensation
...wouldn't be used either but I'm not sure. Any other tables no longer used with SD?? Thanks guys!
Last edited by Jack_of_Trades; Oct 21, 2009 at 03:56 PM.
#611
Is this true for the SD XML's as well? I noticed the MAT tables looked way different than my 94170015 SD ROM, but figured it was an attribute of the new XML/ROM. I only copied RPM VE and MAP VE tables and didn't touch the MAT tables. I'll shoot phenem an email to update his first post to add that detail if it needs to be changed for the SD guys.
#612
R3compile hooked us up w/ that 1. Thank You R3compile!
#613
Is this true for the SD XML's as well? I noticed the MAT tables looked way different than my 94170015 SD ROM, but figured it was an attribute of the new XML/ROM. I only copied RPM VE and MAP VE tables and didn't touch the MAT tables. I'll shoot phenem an email to update his first post to add that detail if it needs to be changed for the SD guys.
The MAT table is setup to pull temperature from the fuel sensor and you would need to change a table to have it pull from the GM IAT and adjust the MAT table appropriatly. Look at the jscbanks thread on SD: https://www.evolutionm.net/forums/ec...y-patches.html
#614
guys, i am gonna use 9653 on a JDM 8, the rear O2 needs to be disabled, but i rather not do it by bis since it affects logging the fuel trims.
is tephra's mod: rear O2 simulator applicable here? work without any CELs?
is tephra's mod: rear O2 simulator applicable here? work without any CELs?