ill try the 0055 tomarro. the NLTS is wat it comes as same as the periphery 7, all 004D.

 

I guess it could be that evos have 2 clutch sensors and eclipses dont? so how would i turn off the need for the sensors for the rev limiter to work? The stationary rev limiter worked fine on the 94170008, IDK?

 

OK, if it worked using another Rom, then the switches shouldn't be the problem. Though I don't have a car to test this on, I think I remember the launch control not working any lower then 5000 RPM. I'm probably wrong, so I'd like someone else to correct me on that one. As another test, set the stationary rev limit to 5000 rpm to see if it works.

For the immobilizer: That first line in the periphery 7 (0xffa) should read one of the immobilizer hexes previously mentioned (0040,0055,0058) . I'd use that to double check the change made to the immobilizer hex.

 

That would suck, then i wouldnt be able to use it. Anyone else have this problem?

 

+100,000!!! I need this!!! its my crack!


Evan Smith

 

Donations would probably speed things up

 

to add to your list.

i have an 2006 evo IX edm version that uses the immob hex 006C.

Mike

 

This XML is for th 9653 ROM for EVO 8's only.

 

Anyone else having problems with the Stationary Rev-Limiter? I switched back to 94170008 and it still works on that rom so its not the sensor, has to be something with the 96530706 rom. Any Ideas?

 

^ It revs freely past your set value?

 

yup!

 

I noticed you have lean spool disabled by setting it's rpm values to = 0. Rather than doing it that way set them to stock and disable periphery FBA bit 0. Set it to = 0.

Lean spool may have something to do with your launch map not working right.

 

I just setup 88590715 on my EVO IX and am getting a code:

P0037 - Heated oxygen sensor (rear) heater circuit low

I am running a wideband o2 sensor to the rear o2 sensor input, and have the rear o2 simulator enabled in the Tephra options.

Anyone run into this before? I was running the same physical setup with 5.10 (rear o2 simulator, OBD inspection pass mods) and never got a CEL.

 

Disable the heater CEL with the O2 heater disable table
Make sure you have 0009 in the Rear 02 heater patch
Disable periphery FAA bit 1.

 

ill try that but it using the launch maps just not rev limiting.