fuel trims seemingly not moving in evoscan
#16
Thread Starter
Evolved Member
if trim doesnt budge after 6minutes with LOW fuel trim and you have did what i said above with the battery and starter then you must go inside ecuflash and alter the CLOSED LOOP - LT FUEL TRIM CONTROL.. chances are the car is showing more HZ then what it normally does from factory so it will be stuck in open loop and low trim will never move.
my idle hz are 31 ish so pretty std
#21
Evolved Member
iTrader: (1)
Joined: Apr 2008
Posts: 563
Likes: 0
Received 0 Likes
on
0 Posts
From: EUROPE
Could be that it is a Evoscan issue.....
Try to read fuel trims with another logger (Mitsulogger) and see if it works.
If you have FAA bit 4 set to 1 the fuel trim must work.
What air flow Hz reads Evoscan?
Also put FAA bit2 and FEA bit15 back to stock (if you have other changes here) and try to read fuel trims after you change those two bits....
Could be something........
Try to read fuel trims with another logger (Mitsulogger) and see if it works.
If you have FAA bit 4 set to 1 the fuel trim must work.
What air flow Hz reads Evoscan?
Also put FAA bit2 and FEA bit15 back to stock (if you have other changes here) and try to read fuel trims after you change those two bits....
Could be something........
#28
Thread
Thread Starter
Forum
Replies
Last Post
tephra
Evo X Engine Management / Tuning Forums
168
May 15, 2012 11:24 AM