elhalisf

iTrader: (171)

I am having a problem with Evoscan. It will log just fine under idle and cruising and a little bit of boost. But as soon as i got into WOT, evoscan will disconnect from the ecu. It will auto reconnect when i am not on WOT.

Any suggestions on what could be wrong.

nothere

iTrader: (23)

is your wideband staying on during wot?

try do a log without the wideband connected

elhalisf

iTrader: (171)

well, it happens if i have the wideband connected or not. but when it is, it stopps logging the WB.

PaperClip

iTrader: (3)

i think that means you have too much power lol

dyezak

iTrader: (3)

You scared EvoScan. Apologize to it, console it, and try again.

03EVOGUY

iTrader: (1)

^^^^^

Evoryder

iTrader: (55)

I have the same problem with my Mitsulogger logging my zeitronix wideband /egt/boost. When I use mitsulogger and the zeitronix logger as separate programs no issues.

elhalisf

iTrader: (171)

it happens even when i am not using my zeitronix.

codgi

iTrader: (22)

Are you logging with a laptop? Can you get a 2nd person to hold the laptop specifically the connector to the cable?

elhalisf

iTrader: (171)

Tried this on a friends car, with the same results. i even updated the evo scan software with no change as well.

nothere

iTrader: (23)

did you try a different cable?

elhalisf

iTrader: (171)

no i havent because i dont have acess to another one. but why would it be the cable?

nothere

iTrader: (23)

can't help but think there is a connection that is intermittent

fryedchikin

Sounds like you have ruled out an issue with the car so that leaves Software,Laptop and Cable. I would try Mitsulogger, if still the same thing happens then try a different Laptop.

gsxwingz

iTrader: (11)

Hey Faisal,
This is due to your Hard Drive motion detection. Go into start menu find toshiba hdd protection, and disable it. Rev2.7 gets rid of this problem.