Seeing 2-3 degrees difference in timing mp vs log.
#21
Evolving Member
iTrader: (1)
Address 840B is a hack that tephra wrote into the ROM for version 7, you cannot change the value that 1 byte load logs. You would have to contact tephra and have him re-write the protocol for the address at 840B. Like boosted originally suggested log both 1-byte load at address 41, and then change your MUT table address for for positions 00, and 01 for 2 byte load. Quick question before you do that, are you using the patch to log airflow in g/s or lb/min? because if you are then you will no longer be able to as these addresses are currently located in MUT locations 00, and 01. Also if you change them be sure to uncheck the tephra option in EcuFlash for "Enable airflow calcs"
Hope this helps,
George
Hope this helps,
George
#23
i only know of 2 timing requests. actual timing and TimingMap/TimingRAW. TimingMap/TimingRAW is what the ECU is targeting and the other is what the enging is actually doing.
again i only know the address for an ADM IX so not sure if your address is correct or not. maybe someone can advise
cheers
again i only know the address for an ADM IX so not sure if your address is correct or not. maybe someone can advise
cheers
#24
I mis titled the log, but the loads between v7 and 2b were so close mostly with in 10 load, and even more within 5 that it doesnt explain the obvious 2* difference where I have 0* in my map, and that log pulls 2*! not much knock there but its there at times.