After doing some logging and trying to tune on ECUFlash, I'm not sure which "Load" item to go off of (Load Calculated, Load11Bit4, ECULoad, Load 1Byte, etc). I'm using EvoScan 2.8 and Tephra V7, Load Calculated is the only one that looks to match but I'm not sure. Need somewhere to start if someone can point me in the right direction.

 

You should do a search for 2 byte logging of load and rpm and airflow. It's the best imo unless you're running a tephra mod then you would use 1 byte. You can swap to 2 byte logging pretty easily with some mods to the mut table, its dependant on what Rom you are using though in regards to which mut addresses to change.

 

Yah either 1byte or 2byte load

 

My 2byte load numbers are showing around 4700 but I'll mess with it some more. It is using a Tephra V7 rom but just trying to get the right load #s logged so I'm tuning the right places on the fuel and timing maps.

 

What are your 1 byte showing? At 26~ psi my load is in the 280-290 range

 

That's the same area mine's at 27psi, more around 310.

 

That's interesting, I don't hit 310 until 29ish, I'm running a ported evo 9 turbo so maybe that's why