EvoDan2004

iTrader: (94)

maybe i can be made as the thread maker???? the guy has not been on the site since 2009....... if they can make me the thread maker ill update this thread

David Buschur

iTrader: (53)

Contact Noize on here Dan, he is one of the higher moderators and is a good guy to work with. He may change it for you, I think it's a reasonable request.

EvoDan2004

iTrader: (94)

thanks david. i will send him a message.

Noize

iTrader: (24)

This will take some MAD SKILLZ, but I'll get to work on it right away.

Noize

iTrader: (24)

Not bad work for 5 minutes, eh? Dan, you have the top 3 posts, sir.

mullen

iTrader: (10)

now on to the task of withdrawing factual info from 60+ pages haha

EvoDan2004

iTrader: (94)

Thanks noize. I have a few ideas to make it nice too. It will take a while but I promise I will get it done. Bare with me guys and any help would be great.

Also all the weights that are listed Will be posted. If you think its wrong we can talk about it.

badev0

iTrader: (74)

Dan I will Pm you a list of all weight reduction savings #s tomorrow ive done to help.

RLLN247

iTrader: (8)

Here are some weights I gathered when I switched to a small koyo radiator.
Stock rad. empty 9.1
stock rad. full 16.0

Stock fan 8.1
Slim fan 4.6

Koyo half rad. empty 6.3
koyo half rad. full 9.0

total savings about 11 lbs.

B.J.@ToxicFab

iTrader: (26)

EvoDan running the weight reduction thread! Sounds good!

EvoDan2004

iTrader: (94)

ok here i go. i have a little bit of time right now to put into this. so here go's nothing.

here is how it will work. the 1st post will be freebie type parts and OEM stock parts weight list.

the 2nd post will be all aftermarket parts. right now i need to sort it out so ignore the mess. i will get it sorted out. i just posted it to have on 1 page while i organize it. a lot of this came from my other weight reduction thread. but i will go threw each page and update every where i can. special thanks to the major contributors will be recognized in the 1st post.

EvoDan2004

iTrader: (94)

i am done for tonight. let me know how i am doing. if you feel i need to change the lay out now is the time to tell me. otherwise except it you picky bastards. hahahaha.

tomorrow night i can spend a few more hours on this. PM me with whatever you have and ill get it up there shortly.

EvoDan2004

iTrader: (94)

ok so i am not done for the night. i put a coat of spackle on the walls and then became bored. so i weighed a few things and posted them up.

does anyone know the weight of the trans mount made by torque solutions??? i just weighed my avid mount. i was pretty disappointed.

back in the garage i go to weigh more junk

B.J.@ToxicFab

iTrader: (26)

DB will probably post it before me but I have both the Torque Solutions 5 spd trans mount & pass. mount weights written down at home...I have a small list of random stuff I have weighed, I'll post it all tonight after work...

AngryEvo8

iTrader: (41)

Was browsing ebay ands came across this..seems legit an lightweight http://item.mobileweb.ebay.com/viewi...id=87779735338