JIC DP installed 05 GSR..pics
#1
Evolved Member
Thread Starter
iTrader: (5)
Join Date: Feb 2005
Location: Phoenix
Posts: 1,545
Likes: 0
Received 0 Likes
on
0 Posts
JIC DP installed 05 GSR..pics
Installed the new JIC Bullet DP for my 05 GSR.
There are clearance issues with the lower tie bars. JIC provided spacers but all they do is allow it to touch the DP. Rattles a bit. Plenty of room around the oil pan and ACD. Pretty common to touch the tie bars though from what everyone posts.
I emailed them to ask what they think.
There are clearance issues with the lower tie bars. JIC provided spacers but all they do is allow it to touch the DP. Rattles a bit. Plenty of room around the oil pan and ACD. Pretty common to touch the tie bars though from what everyone posts.
I emailed them to ask what they think.
Trending Topics
#8
Evolved Member
iTrader: (5)
Join Date: Aug 2003
Location: Phx,AZ
Posts: 1,209
Likes: 0
Received 0 Likes
on
0 Posts
way 2 go! i have the same DP and exhaust. i love the sound and power it makes. i had a RMR DP<without tapers> didnt experience any difference in power or torque. ppl just see that taper and freak out. JIC makes a very good DP-exhuast. WAY 2 GO!
#9
my hks does not have that problem on my 05, instead of hanging to low and needing spacers it sits too high, and the the top of it is rubbing against the subframe near the cat..depending on engine acceleration positions......
#10
Evolved Member
Thread Starter
iTrader: (5)
Join Date: Feb 2005
Location: Phoenix
Posts: 1,545
Likes: 0
Received 0 Likes
on
0 Posts
as far as the tapers go, it matches the output of the stock O2 housing up front, that donut gasket ( is that what its called ) fits right into the opening of the DP so that eliminates that restriction, and the aft end goes into the stock cat, another restiction. I dont have a prob with it.
I kinda wanted to stay with one company rather than mix/match parts. The JIC does have a nice sound.
I kinda wanted to stay with one company rather than mix/match parts. The JIC does have a nice sound.