MSD DIS-2, CBR coils, DSM ignitor...
#61
Evolved Member
iTrader: (22)
Join Date: May 2003
Location: Ozark, MO
Posts: 1,689
Likes: 0
Received 0 Likes
on
0 Posts
No problem. for anyone else you can use 1g plug wires depending on the location placement of your coil (might need two sets to use the long ones). You also have to cut the boot covers so the will go down into the head to snap on.
I believe a perfect fit would be 91 3000GT VR4 plug wires but I haven't confirmed that yet.
I believe a perfect fit would be 91 3000GT VR4 plug wires but I haven't confirmed that yet.
#63
Evolved Member
iTrader: (22)
Join Date: May 2003
Location: Ozark, MO
Posts: 1,689
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by pjsevo8
where does everyone have their coil packs mounted in the engine bay. Looking for some ideas. If anyone could post pics that would be appreciated.
thanx
PJ
thanx
PJ
Another good place was creating a plate to mount it right beside the valve cover just as I believe Trinababe and Nthecrux did. I believe Trinababe's pics are in the earlier pages.
#64
Back from the depths
I just hooked up my ignition last night. I have 300m coils with a aem c2di ignition box and Im having the same problems. I have the aem set to all cdi systems except ford tfi. But under light load my car bucks and misfires pretty bad. Under full load/throttle it runs great.
Should I try the viper dwell settings? On my dip switches i have it set to Off, On, Off.
--Josh
Should I try the viper dwell settings? On my dip switches i have it set to Off, On, Off.
--Josh
Thread
Thread Starter
Forum
Replies
Last Post
johnashton11
General Engine Management / Tuning Forum
11
Sep 13, 2019 01:23 PM