Need Advice Tonight! Maf Sensor Issue
#1
Evolving Member
Thread Starter
iTrader: (2)
Join Date: Apr 2006
Location: Maricopa, AZ
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
Need Advice Tonight! Maf Sensor Issue
I have the hood popped, and the air filter removed, and following a site that was linked on evom, http://spydermagazine.com/2002/March.../maf_clean.htm i removed the sensor wire, and undid the 2 screws for the maf sensor, but i can't get it out. am i supposed to? I got pissed, and removed the whole air box, and it's currently sitting on my garage floor. there is 1 tiny wire inside the airbox, and a large metal piece that goes from top to bottom. am i supposed to clean either one of those? am i just an idiot? HELP!
btw, i know the site's for mr2's but it's all i could find for help on this.
btw, i know the site's for mr2's but it's all i could find for help on this.
#2
yep just clean them both with a lil rubbing alcohol and a q tip... take it inside sit at the kitchen table and take your time.... take your time... take your time... just wipe it all clean with the q tip, I even used a piece of yarn to floss between haha but don't forget, just take your time a new maf is $$$$$ mine idles better now than before good luck...
Thread
Thread Starter
Forum
Replies
Last Post
DJ Brett B
General Engine Management / Tuning Forum
31
Nov 22, 2006 04:14 PM