Most PSI on Boost Juice
#1
Evolving Member
Thread Starter
iTrader: (2)
Join Date: Nov 2006
Location: MI
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
Most PSI on Boost Juice
I am going to buy the Stage2 Snow Performance Meth kit and I am going to use the boost juice with it, which is 49%meth and 51%water. What is the most PSI that I can run with my setup??
03 Evo VIII
Evo 9 Turbo
Megan TBE
eBay o2 Housing
BC 272s
IX BOV
PPi Ported Manifold
AMS FMIC
KN Drop In
I made 333/318 on a DynoJet and wanted to also know if it will be possible to hit 375 with the addition on meth. Comments welcome please.
03 Evo VIII
Evo 9 Turbo
Megan TBE
eBay o2 Housing
BC 272s
IX BOV
PPi Ported Manifold
AMS FMIC
KN Drop In
I made 333/318 on a DynoJet and wanted to also know if it will be possible to hit 375 with the addition on meth. Comments welcome please.
#2
Evolved Member
iTrader: (9)
The amount of boost applied will depend on the extent you go overboard on timing and the amount of fuel added to control knock.
Can't really state a good psi to use it will vary.
Try starting with 24 psi with less than 12:1 A:F and use the stock timing ROM with the load rescaled to 280%. Just fine tune the timing and use the boost to get the power
Can't really state a good psi to use it will vary.
Try starting with 24 psi with less than 12:1 A:F and use the stock timing ROM with the load rescaled to 280%. Just fine tune the timing and use the boost to get the power
Last edited by C6C6CH3vo; Apr 16, 2007 at 02:44 PM.
#6
Evolved Member
iTrader: (8)
Join Date: Aug 2004
Location: FLORIDA
Posts: 1,073
Likes: 0
Received 0 Likes
on
0 Posts
I would also use a heavier weight engine oil. I noticed after braking down my engine after 5,000 miles of running alot of Meth, i noticed alot of cylinder wear.
Look into a better oil to fight against this.
Look into a better oil to fight against this.
Trending Topics
#8
Evolved Member
Thread
Thread Starter
Forum
Replies
Last Post
Knguyen228
Water / Methanol Injection / Nitrous Oxide
6
Jun 5, 2011 06:05 PM
Mellon Racing
Evo Dyno Tuning / Results
9
Dec 31, 2009 12:15 PM