JordanS4

iTrader: (11)

I recently installed my turbo smart eboost 2. I have port 3 hooked up to the compressor, port 2 on the WG, and port 1 venting out. I did not hook up any of the RPM functions, just the boost solenoid and the actual TS unit. It won't boost any higher than 18 psi, no matter I do with boost, WG, or sensitivity settings. I correctly programmed the overboost function. I don't have any visible leaks or bad connections. What am I doing wrong?

Thanks

JordanS4

iTrader: (11)

should I unplug the stock BCS?

nothere

iTrader: (23)

the stock unit is pretty well castrated if it doesn't connect to anything.

right at the moment I am having a senior moment and can't recall the directions, but if you follow them you should be good.
there are a number of gates you need to go through to get the boost where you want with the eboost 2, just follow the directions to the tee.

04WWRS

iTrader: (18)

Jordan, there is a shop in Baltimore called Agile Automotive. Give them a call and ask for Hill. They use these alot. I'm sure he can help you out.

JordanS4

iTrader: (11)

Thanks Joe, called them earlier today and they never returned my call. Ill call back tomorrow. I completely unplugged the stock BCS and added a restrictor pill from the compressor side and im boosting 21 but no more.

JordanS4

iTrader: (11)

bump for help!

nothere

iTrader: (23)

ok Jordan what are your settings and what turbo do you have?

sensitivty, WG , boost number, and whatever else you got.

JordanS4

iTrader: (11)

I have the WG at 16 psi on stock turbo and actuator, I also have my boost and sensitivity at 70 and 70 respectively, but I've varied them both in a number of ways all the way up to 99 and 99.

nothere

iTrader: (23)

try a gate pressure of 1.0 sensitivity of 17 and a 67 or so the range.
these numbers work for a WR turbo, a not to different turbo, but should get you in the right ballpark.

if you lost your instructions you can download them.

JordanS4

iTrader: (11)

Wouldn't keeping the wastegate closed as long as possible be better than opening it at 1 psi? I'll try these settings in an hour and get back to you.

JordanS4

iTrader: (11)

The WG @ 1, Sn at 17 and boost pres at 67 didn't make a difference.

JordanS4

iTrader: (11)

Ran the line off the DV not the Compressor Housing and it works now!

nothere

iTrader: (23)

its an awesome controller, glad you have it figured out now.
after you get it dialed in post what your settings are.