ETS 57 trim Dyno Graph
#1
Evolving Member
Thread Starter
iTrader: (8)
Join Date: Aug 2006
Location: Alaska
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
ETS 57 trim Dyno Graph
Finally found the graph so here it is:
mods:
3" TBE
3.5" ETS FMIC and 2.5" piping
Walbro 255 with mod
RC 1200cc injectors
ETS intake
ACT 6 puck with stock PP (slipping)
rod bolts
stock cams
ETS 57 trim turbo kit
E90 at 26 psi dropping to 24.5-25psi
as you can see there is some boost issues around 4500-5000 because the tial 38mm is setup for a mbc while I have an ebc. I was able to smooth it out a bit but not completely as you can see on the last run. My injectors and pump were at its limit as you can see with the low boost. Ideally I would like to run 30psi. Also on run 6 we were just starting to get the car tuned when the tach pickup quit working until run 21 where not only was the car extremely hot but the clutch just couldn't hold all the power. It wasn't slipping too bad, but it made a difference.
I love how good this car sounds, very smooth sounding exhaust
mods:
3" TBE
3.5" ETS FMIC and 2.5" piping
Walbro 255 with mod
RC 1200cc injectors
ETS intake
ACT 6 puck with stock PP (slipping)
rod bolts
stock cams
ETS 57 trim turbo kit
E90 at 26 psi dropping to 24.5-25psi
as you can see there is some boost issues around 4500-5000 because the tial 38mm is setup for a mbc while I have an ebc. I was able to smooth it out a bit but not completely as you can see on the last run. My injectors and pump were at its limit as you can see with the low boost. Ideally I would like to run 30psi. Also on run 6 we were just starting to get the car tuned when the tach pickup quit working until run 21 where not only was the car extremely hot but the clutch just couldn't hold all the power. It wasn't slipping too bad, but it made a difference.
I love how good this car sounds, very smooth sounding exhaust
Last edited by uglyevo; Aug 31, 2007 at 07:24 AM.
#6
Evolving Member
iTrader: (10)
Join Date: Jul 2006
Location: PortlanD Oregon
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
What’s up with they dyno? Paul's car did fine today! Let me know and I can get it fixed. btw you're car sounded great.
-Kyle
-Kyle
Last edited by HPF Kyle; Aug 30, 2007 at 02:49 PM.