You don't need the red button to calibrate it because I didn't use it to recalibrate mine. Look at the link that 4kinboost posted for the LC-1 and do the initial calibration over again.

 

Alright I read the directions and how to do the initial Calibration. Since its already installed I simply need to take the sensor out, then disconnect the sensor from the lc1, then give it power. Can I just turn my accessory on with the key to give it the power it needs??

 

That's what I did. After that it worked like a charm. Just follow the instructions on the initial calibration and you can't go wrong. I hope everything works out.

 

just got my lc-1 and db gauge in the mail.. not the thread i wanted to see. good luck and let us know if the recalibration is the answer.

 

Just ensure you install it correctly and do the initial calibration and you shouldn't have any problems.

 

alright hopefully i can get around to trying that tomorrow. any other suggestins to make for an easy calibration.

 

Well i found out what my problem was.. My analog output 2 was putting out 10 volts insted of the normal 5 volts, so I turned the volts down to 2.45 max and it is working fine now..

 

how did you do that???

 

In the logworks software click channels on top then configure channel.