Unstable AFR at low throttle
#16
Evolving Member
iTrader: (12)
Lean Spool Disable
Why?
When in open loop operation, the factory ECU artificially leans the fuel mixture by about 1 full ratio point which can cause difficulty in tuning for proper AFR. Disabling "Lean Spool" will also allow for your map AFR numbers to more closely align with your actual measured AFR.
Why?
When in open loop operation, the factory ECU artificially leans the fuel mixture by about 1 full ratio point which can cause difficulty in tuning for proper AFR. Disabling "Lean Spool" will also allow for your map AFR numbers to more closely align with your actual measured AFR.
#20
Evolved Member
iTrader: (5)
Join Date: Jul 2004
Location: ORLANDO
Posts: 974
Likes: 0
Received 0 Likes
on
0 Posts
Mine does that same thing Fluctuating afr during cruise lets say I am going 55 in 5th at steady rpm it will be fine for a bit until it will start going between 12.5 & 14.9 very fast, now I can stop that by giving it a little more gas and then it will steady again if I don't give it more gas it will give code 0134 saying that the front o2 sensor not working. I even disconnect the front sensor at the ecu and using zeitronix NBS at 14.7 and other values for better gas mileage. Again if I get my foot off the gas and on again it will start to jump and give the same code. my wide band is very new.
Thread
Thread Starter
Forum
Replies
Last Post
Raceghost
ECU Flash
22
Jun 1, 2016 12:30 AM
Anubis18
Evo X Engine Management / Tuning Forums
1
Sep 20, 2013 02:39 PM
nj1266
Evo X Engine Management / Tuning Forums
125
Jan 12, 2010 07:37 AM