Pics of Buschur double pumper installed please
#18
Evolved Member
iTrader: (58)
Join Date: Aug 2007
Location: Van Buren, OH
Posts: 1,417
Likes: 0
Received 0 Likes
on
0 Posts
I hate doing f/p's just because of the damn black ring and the space there..... i always joke about trimming it but haven't actually done it yet.
I threw the hose on but didn't feed it down under the car but i think you get the idea.....is that the way yours looks?
Please let me know if the orientation of the assembly is incorrect.
I threw the hose on but didn't feed it down under the car but i think you get the idea.....is that the way yours looks?
Please let me know if the orientation of the assembly is incorrect.
#22
Evolved Member
iTrader: (58)
Join Date: Aug 2007
Location: Van Buren, OH
Posts: 1,417
Likes: 0
Received 0 Likes
on
0 Posts
I just looked at mine. Mine sits the same way. I just bent the floor up a little but and then shoved the cover over it. It bent the cover a little but it fit fine.
As for the wires I ran the power to the front since you have to hook in the pressure switch. The ground wire I hooked to one of the tie down nuts that hold the ring in place.
As for the wires I ran the power to the front since you have to hook in the pressure switch. The ground wire I hooked to one of the tie down nuts that hold the ring in place.
#23
Evolved Member
iTrader: (26)
Join Date: Oct 2007
Location: Colorado Springs, CO
Posts: 1,989
Likes: 0
Received 0 Likes
on
0 Posts
Thanks buddy!! Just what I needed to hear!! Did David hook yours into the AEM?
Reason I ask is that I am on the AEM and my tuner would like to have it AEM activated instead.
-E
Reason I ask is that I am on the AEM and my tuner would like to have it AEM activated instead.
-E
#27
Evolved Member
iTrader: (18)
I just looked at mine. Mine sits the same way. I just bent the floor up a little but and then shoved the cover over it. It bent the cover a little but it fit fine.
As for the wires I ran the power to the front since you have to hook in the pressure switch. The ground wire I hooked to one of the tie down nuts that hold the ring in place.
As for the wires I ran the power to the front since you have to hook in the pressure switch. The ground wire I hooked to one of the tie down nuts that hold the ring in place.
#28
Evolved Member
iTrader: (58)
Join Date: Aug 2007
Location: Van Buren, OH
Posts: 1,417
Likes: 0
Received 0 Likes
on
0 Posts
Yep, channel locks are your friend for this install. Grab the metal and bend the floor up about 1/2 an inch. And then use a little force to get the cover down and screw it down.
#30
Evolving Member
iTrader: (4)
Join Date: Jun 2006
Location: Kuwait
Posts: 346
Likes: 0
Received 0 Likes
on
0 Posts
Damn I was gonna start this thread too, but my Q is abit diffrenet than the OP.
I just wanna know where did u guys connected the Hobb switch??
I just wanna get an idea where to connect it, pic's would be great
Thanks
I just wanna know where did u guys connected the Hobb switch??
I just wanna get an idea where to connect it, pic's would be great
Thanks