wastegate wont open??
#1
wastegate wont open??
I just finished installing my fp green and my wastegate does not open. I shot up to 20 psi and climbing when I should have been at wastegate pressure of like 12 psi. Whats going on? I didnt hook up the boost lines so I could just run the psi off the wastegate spring. The wastegate came already installed on the fp green so I didnt mess with it.
#4
o ok I was under the impression that no vac line would make it run off the wastegate spring pressure.
I just connected my boost controller and turned it all the way down. I dont wanna test it out yet tho because Im dumb and forgot to put a gasket on the j pipe and now my turbo is leaking oil. But tomorrow when I fix that problem I am going to give it a try and hopefully hooking up my boost controller will fix the problem
What im wondering tho is oil supposed to be leaking from the j pipe? I thought only air goes out through there.
I just connected my boost controller and turned it all the way down. I dont wanna test it out yet tho because Im dumb and forgot to put a gasket on the j pipe and now my turbo is leaking oil. But tomorrow when I fix that problem I am going to give it a try and hopefully hooking up my boost controller will fix the problem
What im wondering tho is oil supposed to be leaking from the j pipe? I thought only air goes out through there.
Last edited by def1; Jan 26, 2009 at 10:31 PM.
#5
Evolved Member
iTrader: (35)
Join Date: May 2007
Location: Austin, TX
Posts: 1,754
Likes: 0
Received 0 Likes
on
0 Posts
I thought that too...maybe check your oil feed and return lines. The return line gasket is notorious for oil leaks, I've heard a few people having leaks from oil seeping past the threads on the oil return bolts, so you need to make sure that's sealed and tight.
#7
Evolved Member
iTrader: (1)
Join Date: Mar 2005
Location: Mesoamerica/ SF Bay Area
Posts: 7,905
Likes: 0
Received 5 Likes
on
5 Posts
Is this a new Green, or a secondhand unit? Do you know whether it is equipped with the FP HD actuator, or the stock IX actuator? The FP heavyduty(HD) actuator is a 16-18 PSI minimum actuator, so if this is the actuator on your Green, it'll be tough getting that particular actuator down to 12#. In contrast, either the stock WGA, or a Forge unit can be adjusted down to 10-12 PSI.
Last edited by sparky; Jan 28, 2009 at 04:30 AM.
Thread
Thread Starter
Forum
Replies
Last Post
BOOSTINAT30PSI
Evo Engine / Turbo / Drivetrain
24
Feb 8, 2017 07:48 PM
the mark w
Evo Engine / Turbo / Drivetrain
29
Jul 14, 2011 08:09 PM