Cbrd bbk
#61
Evolving Member
Thread Starter
Join Date: May 2007
Location: Manheim pa
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
#62
Evolved Member
iTrader: (33)
you have to focus on the gains instead of the final number. you said you gained 130hp over stock right? no if this dyno reads super low which it probably does than your good! with dynos i've learned that you have to look at the gained hp rather than the final number lol
#65
Evolving Member
iTrader: (3)
Join Date: Mar 2006
Location: maryland
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
BBK full with the mods in my sig did 403 whp at 25 psi on CBRD's dyno.
Also was having some boost control issues (damn AVC-R) so the next time with this sorted out I am interested to see what 26 or 27 psi will do.
Also was having some boost control issues (damn AVC-R) so the next time with this sorted out I am interested to see what 26 or 27 psi will do.
#67
Evolving Member
Thread Starter
Join Date: May 2007
Location: Manheim pa
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
I will scan all the charts on Monday. My car made 322 whp at 24.1 psi I have an exhaust but it necks down to 2 1/2 after the cat and then goes to 3 inch then goes back the 2 1/2 again at the muffler chad said. Also i have a perrin high flow cat not a test pipe. He used a stock evo 8 dyno run to show what my car would have down stock. i am going to get a new exhaust and then go from there. wow 403 at 25 psi yeah i am not even in the same ball park. But you do have cams and I know that does make a big difference.
#70
Evolved Member
iTrader: (6)
Join Date: Mar 2005
Location: Harrisburg, PA
Posts: 2,427
Likes: 0
Received 0 Likes
on
0 Posts
That dyno is such a dream killer. A year ago, I dynoed 236whp with a 3" TBE, cone filter and MBC @ 21psi. I'm at 301whp after cams, LICP and test pipe. I feel the cams made the biggest difference.
Cams are an Evo's best friend.
Cams are an Evo's best friend.
#72
Evolving Member
Thread Starter
Join Date: May 2007
Location: Manheim pa
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
#74
Evolving Member
iTrader: (4)
Join Date: Oct 2006
Location: Baltimore, MD
Posts: 378
Likes: 0
Received 0 Likes
on
0 Posts
Any reason you ditched your mesh?
#75
Evolving Member
Thread Starter
Join Date: May 2007
Location: Manheim pa
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts