DIDYSIS

iTrader: (18)

Alright so I have done the clutch a few times and no big deal at all, so now I am again trying to do one and no luck at all. I look in there and it almost looks like the TOB is not all once piece but sliding independently. Smaller shaft and larger donut. Any ideas, I mean I have put a 1/2 inch screw driver in there and still nothing at all. tried with the tranny all the way on, hanging a little off, hanging all the way off as far as it can. About to literaly saw the thing off or something of the sor. Please any ideas any??????????????????????

Evo8luva

iTrader: (6)

try to get a 2-3 foot pry bar in there and give it hell. First time doing the clutch on my car i had a similar problem you are describing.

DIDYSIS

iTrader: (18)

ya I have been trying that for a little while. I hate to tell this guy sorry but I cant get your TOB out especially after I have done it before so many times and it was not a big deal. OK so I am a guy I hate defeat in any way. Its just being stupid as hell

DIDYSIS

iTrader: (18)

Still no luck with this thing.

DIDYSIS

iTrader: (18)

Best thing ever just unbolt the Pressure plate through the side hole and wala, deal with it later out of the car. Worked great. And on my way again.

srtboostin22

iTrader: (7)

x2 Had to do the same thing with mine gl bud

FX11

iTrader: (10)

hey man, I JUST DID THE SAME THING, but heres my post, do what justa4banger wrote

https://www.evolutionm.net/forums/ev...help-help.html