2.5 Trans and Spec Twin Install ... not with out issues
Nov 11, 2009 | 03:30 PM
#46
I just got the opportunity to read Jeremy's (SPEC-01) email. He is sending me a new TOB and Pressure plate. Im still pretty much screwed. The cost of my clutch has now gone up another $650.00. Don't get me wrong.. I appreciate what Spec is trying to do for me here. They are sending me replacement parts for my defective parts. I guess he could just say.. sorry about your luck. But ... Im still screwed. I spent all I had to put into fixing my car. I spent alot of money so that things like this wouldnt happen... Im not even counting the used tranny I purchased and installed 3000 miles ago.. or the 700 and something ACT clutch that came apart after 3000 miles and ruined it with no track use. This sucks
"Limit your downside."
It's good advice to take in both business and your personal life.
I hope things get better for you, and good luck with the replacement parts
Nov 11, 2009 | 07:38 PM
#50
Thread Starter
Evolving Member
iTrader: (13)
Joined: Apr 2006
Posts: 375
Likes: 0
From: South Florida
Im pretty concerned at this point.... I cant afford to pull it apart again really. Im getting a TOB and pressure plate... Is there a possibility that something else can be improperly machined? I dont have a choice in this matter really.. I don't know if this is damaging my brand spanking new TRE trans. Im going to have to fix this on my dime.. minus the warrantied parts... if it ends up being something else in this clutch...
Nov 23, 2009 | 08:45 PM
#53
Thread Starter
Evolving Member
iTrader: (13)
Joined: Apr 2006
Posts: 375
Likes: 0
From: South Florida
Due to scheduling issues my mechanic has had to push my install back. We may actually be able to install it tomorrow. He did bring something to my attention though. It seems that the second disk is only engaging 50% of the splines on the nose of the input shaft.
I have sent an email to Spec01...
As a side note we are 100% positive that the clutch disks were installed facing the correct way according to the labels on them.
I have sent an email to Spec01...
As a side note we are 100% positive that the clutch disks were installed facing the correct way according to the labels on them.
Last edited by WickedWhtMR; Nov 23, 2009 at 08:50 PM.
Nov 24, 2009 | 08:55 AM
#58
Send everything back to spec and get a different setup.. Youre gonna drop another 600 on the install just to see if it "might" work..... Alot of people are having problems, they shouldnt have been so quick to release the clutch without more testing.
Let me know if theres anything i can help you out with rob.
Cheers!
Let me know if theres anything i can help you out with rob.
Cheers!
Nov 24, 2009 | 01:13 PM
#60