Main studs - Align boring really necessary?
#17
Evolving Member
iTrader: (8)
Join Date: Feb 2006
Location: Midland, TX
Posts: 369
Likes: 0
Received 0 Likes
on
0 Posts
Year old thread, fyi.
This is debatable, but I'll have to say no, it's not necessary. The clamp load increase does have the potential to distort the housings. But my bearing clearance and endplay remained the same when I switched from bolts to studs.
You don't have to run oversize bearings when you align hone a block. They cut the caps first, making them shorter, so you end up with the same size hole. It's not like machining a crank.
As long as your measure your clearances properly, you will not have any problems.
This is debatable, but I'll have to say no, it's not necessary. The clamp load increase does have the potential to distort the housings. But my bearing clearance and endplay remained the same when I switched from bolts to studs.
You don't have to run oversize bearings when you align hone a block. They cut the caps first, making them shorter, so you end up with the same size hole. It's not like machining a crank.
As long as your measure your clearances properly, you will not have any problems.
#18
Year old thread, fyi.
This is debatable, but I'll have to say no, it's not necessary. The clamp load increase does have the potential to distort the housings. But my bearing clearance and endplay remained the same when I switched from bolts to studs.
You don't have to run oversize bearings when you align hone a block. They cut the caps first, making them shorter, so you end up with the same size hole. It's not like machining a crank.
As long as your measure your clearances properly, you will not have any problems.
This is debatable, but I'll have to say no, it's not necessary. The clamp load increase does have the potential to distort the housings. But my bearing clearance and endplay remained the same when I switched from bolts to studs.
You don't have to run oversize bearings when you align hone a block. They cut the caps first, making them shorter, so you end up with the same size hole. It's not like machining a crank.
As long as your measure your clearances properly, you will not have any problems.
Tomorrow I'll clean the block and torque the main girdle and the torque plate, both with studs. I'll check the main bores for any distotion with a dial gauge. Next, I'll assemble the crank with bearings and check misalignment with plastigage.
#19
Evolving Member
iTrader: (8)
Join Date: Feb 2006
Location: Midland, TX
Posts: 369
Likes: 0
Received 0 Likes
on
0 Posts
I searched a lot and couldn't find any specific thread with all the concerns.
Tomorrow I'll clean the block and torque the main girdle and the torque plate, both with studs. I'll check the main bores for any distotion with a dial gauge. Next, I'll assemble the crank with bearings and check misalignment with plastigage.
Tomorrow I'll clean the block and torque the main girdle and the torque plate, both with studs. I'll check the main bores for any distotion with a dial gauge. Next, I'll assemble the crank with bearings and check misalignment with plastigage.
Didn't realize this was your thread do with it what you will.
Any results for us?
Thread
Thread Starter
Forum
Replies
Last Post
Craig King
Evo Engine / Turbo / Drivetrain
11
May 19, 2011 07:11 PM
AutoMotoSports
Automotosports - Illinois
10
Dec 29, 2009 01:26 PM
BLKCarbonEVO
Evo Engine / Turbo / Drivetrain
27
Oct 23, 2009 08:31 PM