Holset powered Evo VI
#17
Evolving Member
iTrader: (41)
Join Date: Dec 2003
Location: Coatesville PA
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
Glad to see I'm not the only one. Welcome to the club.
I'm surprised you had to trim the block. I had to take a small piece off the front motor mount to clear the comp housing and shaved some material off the hotside then redrilled and tapped it. Otherwise there were no issues with clearance. I'm VERY tempted to step up to the HX40 sooner than I planned.
I'm surprised you had to trim the block. I had to take a small piece off the front motor mount to clear the comp housing and shaved some material off the hotside then redrilled and tapped it. Otherwise there were no issues with clearance. I'm VERY tempted to step up to the HX40 sooner than I planned.
#24
Newbie
Thread Starter
iTrader: (5)
Join Date: Oct 2004
Location: Middle East
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
Finally got it dynoed with the new 83-74 Borg Warner. Approx 520whp/410wtq on a Mustang. 2.1 bar (30psi) boost on 95RON with some octane booster in a can.
http://tensaituning.com/blog/?p=1712
http://tensaituning.com/blog/?p=1712
#28
Evolving Member
iTrader: (41)
Join Date: Dec 2003
Location: Coatesville PA
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
This is all I have of mine.
http://www.youtube.com/watch?v=FxrZYTUZ8yI
http://www.youtube.com/watch?v=FxrZYTUZ8yI