Kilratio

iTrader: (16)

What is a CAS? and no, I didnt look at my TB.. What would I look for?

tscompusa2

iTrader: (22)

cam angle sensor / crank angle sensor. ------ since cam angle sensor is in the code i would get a new one and see if problems resolved. its about $65 i think and not hard to install. Follow the mitsu guide when installing it so its in proper time. ( edit prob don't even need to remove the actual plates inside, just put on new sensor)

http://www.google.com/products?q=cam...evo&hl=en&aq=f

misfires will certainly occur when the cam sensor blacks out.

btw its not the crank angle sensor - when this sensor goes bad the car will not start up.. it receives no spark period.

Kilratio

iTrader: (16)

As stated in origional post, I replaced the cam sensor and installed a heat shield.

Kilratio

iTrader: (16)

bump.. anymore ideas?

binh

iTrader: (40)

It could be a crank angle sensor still. When my crank walked the car would stall with the clutch pressed in for about a week. Then it would get progressively worse. The car would start here and there then finally gave out. I would replace it just to cross one more thing off the list.

Kilratio

iTrader: (16)

ttt

Kilratio

iTrader: (16)

movin on up...to the top........

Clutchdc5

iTrader: (1)

i just ran into this problem, did anybody figure out what it is

driving about 30-40 mph, and car sudden loss of power and a/f shoots up to 17+/--

its late and i need to get some ideas before i wake up and rip everything apart

GT35MR

iTrader: (11)

check your iacv little harness off of the intake manifold. Myn was loose and it fixed a similar issue.

Clutchdc5

iTrader: (1)

so...like 10 evo;s has the same problem and nobody found out what it is