Tomei arms m7960
#77
Evolving Member
iTrader: (6)
Join Date: Sep 2006
Location: Tucson,Az
Posts: 348
Likes: 0
Received 0 Likes
on
0 Posts
I want to say the WGA was preloaded to what everyone recommends, maybe a little bit more (The rod will need to be pulled over the pin so that 1/4" of the hole on the rod is covered. 3/4" of the rod should be empty). So the WGa spring is 23 psi, and the car is boosting 25psi with just the WGA. Once I add the Boost Controller, turned all the way (high boost), I only get an increase of 3-4psi max.
I keep scratching my head, but I think it might be the spring on the boost controller is no longer holding, so either change the boost controller or change the spring.
Also, hypotetically speaking, if I was to preload the wga more than the "recommended" what could happen? can the flapper be bent? damaged?
Thanks
Regards
Thread
Thread Starter
Forum
Replies
Last Post
Randal
Evo Engine / Turbo / Drivetrain
15
Aug 30, 2013 08:39 AM
Randal
Evo Engine / Turbo / Drivetrain
39
Sep 24, 2012 12:10 AM