Turbo Spooling VERY slow.
#18
I was re tuning it when I noticed this. Spool up afr are at 12.5 then down to 11.5 at peak boost and 11 at 7k. The hks cams are installed straight up. It is the old green and I believe it has a stock actuator, However it could be an 18psi actuator as I have never tried to take the mbc below 18.
#21
Well, in all of this bad weather I finally found time to check the wga and sure enough there wasnt even a turn of preload on it. So i turned it to standard and turned the boost all the way down for safety. I get 24 psi of boost. So I am assuming I have an upgraded actuator from fp, is this a safe assumption?
On another note the turbo is spooling significantly faster and I have the typical green characteristics of 15 psi by 3250 and full boost at 4000.
On another note the turbo is spooling significantly faster and I have the typical green characteristics of 15 psi by 3250 and full boost at 4000.
The following users liked this post:
Tommyfacekicker (Mar 24, 2017)
Thread
Thread Starter
Forum
Replies
Last Post