New BW EFR Turbo Thread
#1816
Just so people can see some Supra results and a lot of heated discussions related to the EFR and twin scroll.
http://www.supraforums.com/forum/sho...nifold-Testing
http://www.supraforums.com/forum/sho...nifold-Testing
#1817
Just so people can see some Supra results and a lot of heated discussions related to the EFR and twin scroll.
http://www.supraforums.com/forum/sho...nifold-Testing
http://www.supraforums.com/forum/sho...nifold-Testing
Could you summarize the results?
#1818
They're testing a PTE6266 versus a 8374EFR both twin scroll turbine housings and they're doing both on an HKS style divided manifold/single gate as well as a true divided manifold/ twin gate Full-Race manifold.
I spend pretty much all of page 9 and 10 trying to convince them to do transient response testing.
#1819
No testing has been done yet.
They're testing a PTE6266 versus a 8374EFR both twin scroll turbine housings and they're doing both on an HKS style divided manifold/single gate as well as a true divided manifold/ twin gate Full-Race manifold.
I spend pretty much all of page 9 and 10 trying to convince them to do transient response testing.
They're testing a PTE6266 versus a 8374EFR both twin scroll turbine housings and they're doing both on an HKS style divided manifold/single gate as well as a true divided manifold/ twin gate Full-Race manifold.
I spend pretty much all of page 9 and 10 trying to convince them to do transient response testing.
#1821
early june the compressor outlet v-bands for the 8374 and 9180 are going to be available. after enough whining and crying to borg warner, a distributor will be making the flanges.
#1823
#1826
On a note that might be more immediate to some, has anyone had any update about whether the 9180s are still on target to be available June-July as was the case last time I inquired roughly 6 months ago? Is another delay on the horizon or does production seem to be going according to plan?
#1828
n2oiroc. That's a REALLY hard bend coming out of your turbine. also isnt the wideband supposed to be at least 6 inches from the turbine. something about false readings or shortening the life of the sensor
#1829
youre right, the bend is horrific and im making a new downpipe. as far as the wideband, it will go farther downstream, but not much. i have had good luck with them fairly close to the turbine wheel (6-8"). if its too far away then closed loop idle fluctuates more and the sensor reacts slower.
#1830
youre right, the bend is horrific and im making a new downpipe. as far as the wideband, it will go farther downstream, but not much. i have had good luck with them fairly close to the turbine wheel (6-8"). if its too far away then closed loop idle fluctuates more and the sensor reacts slower.
Damnn! I just saw your PM, I replied to your email. BTW. Which wideband are you using?
Thanks.