i am ordering intercooler ams or ets
#16
Evolving Member
I'm running the AMS (cast sides)with a gt35 on an E7 with a greddy 3" tbe and a custom DP. its laggy!
With an E8 turbo and the full greddy 3" tbe and O2 pipe, it woke up the turbo's spool up. Id say as much as the 3". sorry but no hard numbers.
With an E8 turbo and the full greddy 3" tbe and O2 pipe, it woke up the turbo's spool up. Id say as much as the 3". sorry but no hard numbers.
#22
Newbie
Thread Starter
Join Date: Aug 2009
Location: dubai
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
BUT AMS RACE INTERCOOLER IS DISCONTINUED ....the other ams intercooler is too small ... as for the ets will it bolt to the f1 ams manifold ???? will 5 inch bolt easily with minor trimming or i will have to remove crash beam
#28
Newbie
Thread Starter
Join Date: Aug 2009
Location: dubai
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
i have driven friends car total buschur i dont like it thank you and driven another friends ams setup evo still better saw 3.5 inch ets intercooler at friends house didnt fitted yet but quality was damn good
#30
Former Sponsor
iTrader: (91)
If your running a 35R our 4.0" intercooler will be enough. The 5.0" will fit, but it requires cutting/removal of the crash beam and trimming of the front bumper cover.
The piping for the AMS f1 intake will need to be the AMS piping, we have not mocked up that intake manifold so we don't offer piping for it. However, we do offer piping for the Magnus cast intake manifold. English Racing recently performed a test showing not much difference between the two. If you haven't purchased the intake manifold, this may be something to consider.
The lag between the 4.0" and 5.0" will not be noticeable. The intercooler takes m/s to fill with air. English Racing has actually tested the 5.0" on a stock turbo and they could not feel an increase in lag over the 4.0"
Thanks,
Michael
The piping for the AMS f1 intake will need to be the AMS piping, we have not mocked up that intake manifold so we don't offer piping for it. However, we do offer piping for the Magnus cast intake manifold. English Racing recently performed a test showing not much difference between the two. If you haven't purchased the intake manifold, this may be something to consider.
The lag between the 4.0" and 5.0" will not be noticeable. The intercooler takes m/s to fill with air. English Racing has actually tested the 5.0" on a stock turbo and they could not feel an increase in lag over the 4.0"
Thanks,
Michael