i would like to build 2.0 Litre long rod motor...please can someone share there knowledge and experience...with which off the shelf parts i can build it

thanks

 

I'm building a 2.0 long rod as well.

Using k1 156mm rod's and wiseco pistons

 

which part number did u order? was it wiseco HD piston? im looking for final compression of 8.5.1
with 1.5mm gasket and 43cc heads after porting

which piston are recommended for me to achive 8.5.1

 

My pistons are 85.5mm and have a dish off 21 cc


part nr 6596m855.

there are some reports off them cracking.
But Wiseco is a big name.
They sell a lot off pistons.

And only the bad reports get posted.



Dont know the part nr off my K1's


Comp ratio can be altered with the thickness off the head gasket

 

are those hd pistons what will be ur final CR with 88mm cranks and what gasket thinkness u are using

 

with a 0.030 Squish and a 1.3 mm gasket it wil be 9.0

 

r u sure??...some vendors that i contacted said with the wiesco HDstroker pistons and 156mm rod and 88mm crank the compression will be no more than 7.8.1...dont know how can i get to 8.5.1

 

The stroke is the same and the tdc is the same.

Same as the dish cc's

So the comp ratio is same as a HD piston.

 

Ill be runnin map ultimate rods and hd2s from tscomptuned by far best pricing and great service hell answer all ur questions

 

do u Have the part number....wat compression u will end up with....i will aslo speak to tscomptuned