Possible blown engine need suggestions for short block
Today | 05:05 PM
#16
Headgames is in New Jersey.
If the engine is already removed and the block is going to be machined, you have every excuse to install an aftermarket rotating assembly. I think it would be silly not to. At the very least consider installing rods and pistons. If you really don't plan on aiming for high power then H-beam rods and 4032 pistons are a perfect budget combo.
If the engine is already removed and the block is going to be machined, you have every excuse to install an aftermarket rotating assembly. I think it would be silly not to. At the very least consider installing rods and pistons. If you really don't plan on aiming for high power then H-beam rods and 4032 pistons are a perfect budget combo.
Thread
Thread Starter
Forum
Replies
Last Post
NOMIEZVR4
Evo X Engine / Turbo / Drivetrain
7
Aug 7, 2010 09:06 AM
fast03evo
Evo Engine / Turbo / Drivetrain
33
Oct 27, 2007 01:32 PM