How much play in turbine shaft is too much?
#1
Evolved Member
Thread Starter
iTrader: (10)
Join Date: Jan 2003
Location: Yuma AZ
Posts: 942
Likes: 0
Received 0 Likes
on
0 Posts
How much play in turbine shaft is too much?
I was looking at my turbo while installing new IC pipes and grabed the shaft bolt and tried to move it, it didn't go in or out but it did move side to side slightly. I didn't measure the movement but I would guess around .5MM , barely noticable with my eye but I could feel it with my fingers. The compressor blades look fine. Didn't see where it contacted the housing and there aren't knicks on the blades.
Anybody know if this is bad?
Anybody know if this is bad?
Thread
Thread Starter
Forum
Replies
Last Post
ECS Performance
Evo How Tos / Installations
1
Jan 31, 2010 02:51 AM