All Part Number Request Go Here
#3061
Hi im looking for the part number of the Tweeter cover plastic mesh/grill? on evo 9
Basically i replaced the original driver side pillar with a full 3 pod gauge pillar with tweeter cutout, the problem is the "tweeter cutout" does not include the original protective mesh/grill that covers the speaker hole, attempts to remove this one from the original pillar resulted in the cheap plastic mesh/grill splitting in two.
Anyone know if mitsubishi sells these tweeter covers as standalone parts and if so what would be the part number? im working on getting an image.
Usefull info:
It appears driver/passenger side grill/mesh are identical, just flipped around
It appears most normal lancers also use these cheap plastic grills
Any info locating this part number would be great.
Thank you
#3062
Evolved Member
iTrader: (2)
Join Date: Aug 2007
Location: Norwalk, CT
Posts: 523
Likes: 0
Received 0 Likes
on
0 Posts
I am looking for part # and quote for the nut and bolt on the rear passenger side Lower Control Arm of my 2006 Mitsubishi Lancer Evolution IX. They are used in #12 of the diagram where the two bushings are shown on the right side:
Last edited by Bster13; May 21, 2009 at 08:27 AM.
#3063
iTrader: (256)
#3066
Newbie
iTrader: (6)
Join Date: Jan 2008
Location: Central Coast, CA
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
I am looking for the rectangular plastic cover, that covers a hole in the dash in the middle of the air/defroster vent. I was running a wire and i accidentally dropped the small cover down the same hole and I can't find it. Its about 0.5''x1.5''. I believe the number is right on the bottom of the piece but I forgot to write it down. Thanks for any help.
#3067
I am looking for the part number for the 2 screws which mounts the front bumper to the chassis behind the plastic coverings of the bumper as per the circle in the picture.
Thanks in advance.
Thanks in advance.
#3072
Newbie
iTrader: (8)
Join Date: Dec 2007
Location: philly
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
just did the evo ix front bumper conversion and need the part numbers for the retainer clip and cap back (snap the front bumper to the fender area) as well as the upper left and upper right reinforcement plates.
thanks in advance!
thanks in advance!
#3074
Evolving Member
Join Date: May 2005
Location: Florida
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
Hey russell, I bought some center caps recently from there and when I went to go have them put on, the shop told me they were the wrong ones? I don't get it.
I ordered the ones you told me to.
I can give you my order number and information but I really need these exchanged because I paid 50 dollars for these things. I would greatly appreciate it if you could help me out with this matter.
-Jonathan S.
I ordered the ones you told me to.
I can give you my order number and information but I really need these exchanged because I paid 50 dollars for these things. I would greatly appreciate it if you could help me out with this matter.
-Jonathan S.