kyoo

iTrader: (29)

is there a part that can act as a rubber stopgap for the o2 sensor hole under the passenger side seat?

also, what is the part # for the entire carpet (not mats) that covers the evo floor?

tsidrift1

iTrader: (46)

I need the part number for the mivec line and both banjo bolts.

Thanks!

C6C6CH3vo

iTrader: (9)

Manual Transaxle Control Shaft Boot

Need part number for the boot

* * * EDIT * * *

Disregard request of PN. Got it on order

doncarbone

iTrader: (15)

looking for just the sprocket off the cam gear, the solenoid feed and the filter..

1slowevoixmr

iTrader: (2)

I've been browsing but cant find the part# of strut bar bolts. The two bolts in the middle..

Or anyone from here know the size?

Mas_egypt

Hi guys , i need the part numbers for evo 5 and 6 ecu

todd6027

iTrader: (10)

evo 5
md356472
md360216

evo 6
mr420403
mr420543
mr514364
mr514365

just in case

evo7 also 4 plug but needs some wire swap to fit a 4
mr560648
mr560649

gallas

iTrader: (7)

Anyone know the part number for the front diff ACD banjo bolt crush washer that goes on the top of the diff and the washer itself has a thin black coating on the inside to seal?

I tried a normal crush washer that fit the banjo bolt but it didn't have that black inner ring and is leaking bad. Need help! Please and thank you.

todd6027

iTrader: (10)

MF660065 stock ones are just copper washers they dont have the inner ring those would be hydaulic bonded washers they are 14mm id

s4m

This is great. Gonna help me out so much

haka

anyone know what bolt is used to secure the passenger rear abs sensor in? I went to replace mine and the bolt was missing.

todd6027

iTrader: (10)

8x1.25mm and 20 mm thread length

MS240085

haka

Awesome thank you so much.

dagle

Anyone know if Lancer (non-evo) LCA's will work on an EVO? They look the same, I'm considering the Dorman aftermarket unit instead of paying 3x for OEM used.

06MREvo

iTrader: (90)

Alright guys, I am looking for a couple part #s for some firewall, harness mounting hardware!

This is for the section of harness that goes from the main fuse box along the driver's side frame rail, along the fire wall then through the firewall & under the dash. A lot of this harness is inside black plastic covers. There are (5) pieces of hardware total.

(1) 12mm bolt - Holds harness to driver's side frame rail, (3) 10mm nuts - Hold harness to firewall & (1) 10mm bolt - holds harness to firewall <<(Last bolt before it goes through the firewall & under the dash).