Racing at barber race track!!!!
#1
Evolving Member
Thread Starter
Join Date: May 2005
Location: Birmingham, AL
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
Racing at barber race track!!!!
Just like the title says, at the end of october i get a chance to run my car at barber's motorsports. Now if you know anything about race tracks you'll know how nice it is to run out there. I have everything i need to run out there, exedy twin disk, hks intake, full hks turbo back, mbc set at 24 pounds, and buschar fmic with upper and lower piping, and race tires. Except i want to put cams in but i dont want them to hender me on the track, now away from track i drive a lot on the interstate but i want something to surprise these bmw club guys, so tell me which cams i should go with for this situation and for the daily grind.
thanks jason
thanks jason
#3
Newbie
iTrader: (3)
Join Date: Feb 2005
Location: SoCal
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
I've seen a lot of guys on here talking about auto-x that use the 264 setup because it has a broad power band and starts a little earlier in the rpms. How ever, with your setup and guessing that you will be spending a lot of your time near or close to redline, I would go with the 272 setup. This works great for streetablility and I don't see it hindering you on the track much if at all.
Are you still using the stock turbo? I'm just curious cause I think 24psi would be pushing it to its max...
Are you still using the stock turbo? I'm just curious cause I think 24psi would be pushing it to its max...
Thread
Thread Starter
Forum
Replies
Last Post
aschmuck
Evo X Engine / Turbo / Drivetrain
24
Nov 3, 2015 10:48 AM
9sec9
Vendor Service / Parts / Tuning Review
71
Nov 27, 2007 08:18 AM